**Title: “Transform Your Wltoys 959: Master the Metal Floor Plate Upgrade Like a Pro!”**
(How To Install Metal Floor Plate Wltoys 959)
So you’ve got a Wltoys 959 RC car, and you’re ready to take its toughness to the next level. Maybe you’ve been tearing up dirt tracks or jumping ramps, and that plastic floor plate just isn’t cutting it anymore. Time to swap it out for a metal one! This upgrade isn’t just about looks—it’s about durability, performance, and keeping your ride in action longer. Let’s break down how to install a metal floor plate without breaking a sweat.
First, gather your tools. You’ll need a small Phillips screwdriver, a set of hex keys (usually included with the car), your new metal floor plate, and a clean workspace. Clear a table or desk so you won’t lose tiny screws. Pro tip: Put a towel down to catch any parts that might roll away.
Start by flipping the car upside down. The floor plate is the big piece covering the underside of the chassis. Look for the screws holding it in place. There are usually six to eight of them around the edges. Use your screwdriver to remove these carefully. Keep the screws in a small container—you’ll need them again later.
Once the screws are out, gently pry off the old plastic plate. Check if any wires or components are attached to it. If so, disconnect them slowly. Don’t yank anything! The Wltoys 959 has a simple layout, so this part should be straightforward. Set the old plate aside. Maybe keep it as a backup or turn it into a DIY project later.
Now grab your shiny new metal floor plate. Line it up with the screw holes on the chassis. Make sure it sits flat and matches the shape of the old one. If it doesn’t fit perfectly, double-check the product specs. Some plates might need slight bending, but quality metal parts should slot right in.
Time to secure the plate. Use the original screws to attach it tightly. Don’t over-tighten them, though—stripping the threads is a nightmare. Turn each screw until it’s snug, then give it a tiny extra twist. Repeat for all the holes. Once done, flip the car back over and shake it lightly. If nothing rattles, you’re golden.
Reconnect any wires you detached earlier. This might include power cables or sensor lines. Refer to your car’s manual if you’re unsure where they go. Most connectors only fit one way, so forcing them isn’t necessary. Push until you hear a click, and you’re set.
Test the car before hitting the track. Turn it on and let it idle for a minute. Listen for strange noises or grinding sounds. If everything’s quiet, take it for a slow spin on a flat surface. Check how it handles bumps or quick turns. The metal plate should make the chassis feel sturdier and more responsive.
A few extra tips: Metal plates can get hot during long runs, so avoid touching them right after a drive. Also, if you crash hard, inspect the plate for bends. While metal is tough, it’s not indestructible. Straighten any warped spots with pliers or replace the plate if needed.
(How To Install Metal Floor Plate Wltoys 959)
Finally, enjoy the upgrade! Your Wltoys 959 is now built to handle bigger jumps, rougher terrain, and whatever else you throw at it. Show it off at the next RC meetup—your friends might just ask you to help with their upgrades too.
Inquiry us
if you want to want to know more, please feel free to contact us. (nanotrun@yahoo.com)